4 PGM Expansion Module

Code: PA3806

FEATURES:

• Compatible with Compatible with Spectra SP (V3.00) and Digiplex EVO
• 4 fully programmable 5A relay outputs
• Deactivate PGM after event and/or timer
• Pulse PGM output for fire alarms
• In-field firmware upgradeable

8 Zone Expansion Module

Code: PA5380

FEATURES:

• Compatible with MG Series, SP Series, and E Series
• Add 8 zones
• 1 PGM output
• Use zone input as an anti-tamper switch input

Wireless Expansion Module REM2

Code: PA3809

FEATURES:

• Compatible with Spectra SP Series and Digiplex EVO
• 32 wireless zones
• Maximum number of remote controls: 32
• Remote control compatibility
• SP: REM1, REM2, REM3
• Stand Alone: REM1
• Wireless PGMs (16 w/SP)
• Supports two RPT1 and eight K32LRF / K32IRF (Spectra SP only)
• In-field firmware upgradeable via CV4USB and Winload
• RF jamming supervision
• Low battery, tamper and check-in supervision
• Transmitter signal strength display
• 3 PGM outputs and 1 optional output
• Noise level test and indicator

Wireless Expansion Module REM15

Code: PA3813

FEATURES:

• Compatible with Spectra SP Series and Digiplex EVO
• 32 wireless zones
• Maximum number of remote controls: 32
• Remote control compatibility
• SP: REM1, REM2, REM3
• Stand Alone: REM1
• Wireless PGMs (16 w/SP)
• Supports two RPT1 and eight K32LRF / K32IRF (Spectra SP only)
• In-field firmware upgradeable via CV4USB and Winload
• RF jamming supervision
• Low battery, tamper and check-in supervision
• Transmitter signal strength display
• 3 PGM outputs and 1 optional output
• Noise level test and indicator

Wireless Repeater Module

Code: PA3804

FEATURES:

• Built-in transceiver (433MHz or 868MHz)
• Allows to extend the range of wireless communications
• Supports all MAGELLAN transmitters
• Select which zone, PGM and/or keypad signals are repeated
• Signal strength display
• 1 programmable 5A relay output
• Universal transmitter input (N.O./N.C.)
• In-field firmware upgrade via 307USB and WinLoad
• Wireless range in a typical residential environment:
  - 75m (240ft) with 433MHz;
  - 50m (160ft) with 868MHz
• Note: The RPT1 is not supported by the RTX3 when connected to an EVO panel.
• AC input (16Vac, 20VA)
• Fits in 20cm x 25.5cm x 7.6cm (8in x 10in x 3in) and 28cm x 28cm x 7.6cm (11in x 11in x 3in) metal boxes

Internet Module

Code: PA3805

FEATURES:

• SSL support for sending secured emails via a secure sockets layer; a protocol for encrypting information over the Internet
• HTTPS support for improving security (HyperText Transfer Protocol Secure; a widely used communications protocol for secure communication over a computer network)
• Two I/Os on board; controlled via the web interface, triggering an email
• Event log on web interface; displays last 64 events
• Easy installation; built-in clip for mounting in a metal box
• Report control panel events via IP to the Paradox IPR512 GPRS/IP Monitoring Receiver
• Control and monitor a control panel through an IP network (LAN/WAN/Internet)
• Compatible with Spectra SP series (V2.10 or higher), MG5000/MG5050 (V2.10 or higher) and EVO control panels
• Use NEware, WinLoad or Babyware to access your system through the Internet
• Receive notification of system alarms via email
• Arm/disarm individual partitions via web browser
• View live status of all zones and partitions (e.g., open/close, arm/disarm, troubles and alarms) via web browser
• ParadoxMyHome available for dynamic IP address
• Very low bandwidth consumption
• Supported language: English